Показать сообщение отдельно
Старый 30.01.2022, 12:08   #15
Pin
Супер-модератор
 
Аватар для Pin
 
Регистрация: 08.09.2009
Сообщений: 3,079
Pin на пути к лучшему
По умолчанию

I JCF,
Nope - with current firmware it is not possible to use manifold absolute pressure sensor? because it need 3d conversion table. Because there could be several point with same pressure but at different rpms as a result the real quantitiy of air consumed byt engine will be different.
On board there all hardware for using MAP, firmware is under development. When it will be ready - i'll post it here. At this moment you can use only maf.
Regards
Anton
Pin вне форума   Ответить с цитированием