Показать сообщение отдельно
Старый 14.03.2021, 14:03   #2
Pin
Супер-модератор
 
Аватар для Pin
 
Регистрация: 08.09.2009
Сообщений: 3,079
Pin на пути к лучшему
По умолчанию

Hello.
Sorry it seems that attached pictures are crashed during relocation of this thread.
But i saw them.

This method will not work correctly at all, because the air pressure after you will remove AFM will be much higher and you will get too lean mixture with a new MAF.
We already tried to compare signal and make conversion table with the same method. Moreover earlier versions of firmware and software had a special algorythms and did such a job in automatic mode, but in practice it gave a very bad and unstable results. Thats why we removed this feautures. And it is more better simlier and precise to make a new conversion table with a new maf directly according to oxygen sensor signal.
Pin вне форума   Ответить с цитированием