Показать сообщение отдельно
Старый 22.08.2019, 12:08   #5
Cesco
Новичок
 
Регистрация: 16.08.2019
Сообщений: 3
Cesco на пути к лучшему
По умолчанию

Цитата:
Сообщение от Pin Посмотреть сообщение
Hi.
To find pinout of VAF we typically remove it's plastic cover and watch directly on a board.
First we see the signal from the flap - you see there a slider and it is not difficult to find on what pin it goes.

Next you will see some wires from IAT sensor - one of them is signal - it goes directly on some pin of the VAF's connector. And other wire is connected in parrallel to some pin which is also connected to the ceramic resistive board - this is a GND( ground).

And the last available pin will be a 5 V reference voltage.

If it possible, please attach a photo of your VAF with removed plastic cover - so we can see a slider and a ceramic board - i'll try to show you on this pic.
Ok, i understand that, so other pins will don't connected?
this is the vaf



and this is the connector, i wrote the resistence from slider to each pin

and the voltage on each pin



in other, on my HFM5 have temp sensor, i'll connect that direct to converter?
Cesco вне форума   Ответить с цитированием