Показать сообщение отдельно
Старый 18.08.2018, 22:53   #6
Pin
Супер-модератор
 
Аватар для Pin
 
Регистрация: 08.09.2009
Сообщений: 3,079
Pin на пути к лучшему
По умолчанию

Hi.
You can try to connect it directly , but in some cases as there is low internal impedance of this input of the converter, signal from hall sensor can lost an amplitude and engine will not start and work.
But if you will connect it to the converter and amplitude of this signal stayed the same - you dont need to make a divider.
Pin вне форума   Ответить с цитированием