As i see your AFM has CO potentiometer too.
So you need to dissasemble AFM and measure CO potentiometer's resistance and setting, next you can place the same value and setting external potentiometer in a wiring.
Or you can remove it from AFM and install in wiring .
Also i marked IAT's pins - you can desolder and use it as IAT in new installation.
If i found the right schematic it seems that pinout should be like this
Цитата:
in other, on my HFM5 have temp sensor, i'll connect that direct to converter?
|
No, you shouldn't use it at all. Iat input of the converter is only for genuine iat sensor from genuine AFM if it will be installed and connected, otherwise you dont need to connect this input.