Тема: E28
Показать сообщение отдельно
Старый 23.11.2016, 00:27   #7
Pin
Супер-модератор
 
Аватар для Pin
 
Регистрация: 08.09.2009
Сообщений: 3,079
Pin на пути к лучшему
По умолчанию

Hello Duat
It has the same 70 mm between mounting holes.

For firmware update you can use win xp, win7, vista and win10 should work too.
We have not USB to UART adapters. You can use it if you order one from some internet shop or aliexpress.

But it seems that it will not be necessary update a firmware - i found angle to voltage curves to this throttle body.

Now please open idle switch , so on idle signal wire will be 5v.
After that short this wire through 1kOm resistor to ground and measure voltage on it.
Also remove 1kOm resistor and short this wire to ground via 10kOm resistor and measure voltage.
Let me know both voltages.
This will help understand is it possible to emulate idle switch on our contactless tps hardware.
Pin вне форума   Ответить с цитированием