Показать сообщение отдельно
Старый 30.08.2019, 15:20   #6
Pin
Супер-модератор
 
Аватар для Pin
 
Регистрация: 08.09.2009
Сообщений: 3,079
Pin на пути к лучшему
По умолчанию

As i see your AFM has CO potentiometer too.
So you need to dissasemble AFM and measure CO potentiometer's resistance and setting, next you can place the same value and setting external potentiometer in a wiring.
Or you can remove it from AFM and install in wiring .
Also i marked IAT's pins - you can desolder and use it as IAT in new installation.
Нажмите на изображение для увеличения
Название: M42AFM2.jpg
Просмотров: 440
Размер:	48.4 Кб
ID:	2427

If i found the right schematic it seems that pinout should be like this
Нажмите на изображение для увеличения
Название: M42AFM.jpg
Просмотров: 445
Размер:	35.0 Кб
ID:	2426
Нажмите на изображение для увеличения
Название: M42Pinout.jpg
Просмотров: 402
Размер:	39.7 Кб
ID:	2428


Цитата:
in other, on my HFM5 have temp sensor, i'll connect that direct to converter?
No, you shouldn't use it at all. Iat input of the converter is only for genuine iat sensor from genuine AFM if it will be installed and connected, otherwise you dont need to connect this input.
Pin вне форума   Ответить с цитированием