Hi Rohan
Цитата:
First up I grabbed the 5v from the vaf sensor, should I take this from the pcb/converter board?
|
It is ok to take it from VAF
Please install jumper to motronic position (1-2) and check voltage with a multimeter between ground and jumper - there should be 5v. If there is no 5v let me know.
If it is ok, then disconnect converter's output from ECU and upload next table to converter( don't forget to save your table before it).
After that please check voltage between output and ground there should be ~2.55v
Let me know a results
Regards