Вернуться   Форум Pilot Engineering > English forum > Click here :) > Pilot VAF/MAF converter

 
 
Опции темы Опции просмотра
Старый 14.03.2021, 11:40   #1
ALFAMAF
Пользователь
 
Регистрация: 26.12.2020
Сообщений: 5
ALFAMAF на пути к лучшему
По умолчанию ALFA ROME0 2.5V6 VAF to MAF Conversion Function

I have developed the following method to determine the relationship between Bosch VAF output and the HFM5 MAF I will use. ( Bosch 0 281 002 537).
I arrange the airflow through both sensors via adjustable bleed off valves to vary the airflow and connect to 2 X Vacuum cleaners. The airflow through both VAF and MAF will be the same. See the attached photos. Note the slightly unstable nature of the MAF signal in my setup so I plot Min/Max/Avg values.
Apply appropriate supply voltages to both devices and the following graph produced. I should then be able to load this data into Pilot VAF/MAF configurator and get a very close tuning result. I hope.
I will ignore the low value data.
I will smooth the mid flow lump as I suspect not real.
I can extrapolate the curve to the higher airflows which I could not achieve.

Последний раз редактировалось Pin; 14.03.2021 в 12:53.
ALFAMAF вне форума   Ответить с цитированием
 

Опции темы
Опции просмотра

Ваши права в разделе
Вы не можете создавать новые темы
Вы не можете отвечать в темах
Вы не можете прикреплять вложения
Вы не можете редактировать свои сообщения

BB коды Вкл.
Смайлы Вкл.
[IMG] код Вкл.
HTML код Выкл.

Быстрый переход


Часовой пояс GMT +6, время: 21:14.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd. Перевод: zCarot